Repair and maintenance of  pneumatic combination s

  Due to the wear work parts, screw loosening air pressure reducing reason, machine will malfunction, so to be ruled out in time, make pneumatic steel strapping tool function properly and smoothly work, the cause of the fault has the following several aspects.
  1, In a pneumatic motor and a cylinder body and all transmission, rotating parts, each class before use, must be lubricated with oil, the amount of additional, should be filled with 22# gas wheel oil regularly and quantitatively in the oiler in the oil supply to maintain a fixed, when the pneumatic motor work, lower from the oiler drops of oil is 40 - 60 drops of /min best.
  2, compressed air does not match the 0.4 - 0.6Mpa, must be given to adjust, otherwise, too low pressure will affect the binding quality, high pressure can make the machine wear too fast.
  3, lubricator, oil water separator every three months using kerosene wash once, and daily removal of stagnant water in oil-water separator.
  4, The gap between the the friction wheel and the pad wheel in between 0.5-0.7mm, otherwise, should be adjusted, and the timely removal of scrap and dirt on the friction wheel.
  5, due to the wear of parts in the long term, environmental pollution, poor lubrication, failure may occur, so the timely discovery, timely elimination of faults is very important, inspection and maintenance of the following, using common tools can be solved, can grasp the following techniques will not be because of the small fault caused by the shutdown, shutdown machine losing valuable time and turn to the manufacturers.