Separate steel strap packing machine is in use process is prone to failure in separate pneumatic steel strap tensioning machine, the following is a Ausense dispatch engineers of some fault in the process of work summary and solution, hope is a good help for the customers.
Fault: tight machine motor won't start.There are three kinds of the fault reason:
(1) . The motor with foreign body
(2) the horse thaddaeus dry, lubricant
(3). Improper valve pressure is insufficient.
Solution is also has the corresponding three kinds:
(1). The packer to manufacturer maintenance
(2). From the air inlet of motor and a few drops of oil
(3) to adjust the air valve.
Fault 2: pressure to the upper straps tight round.Separate steel belt press the breakdown of the four reasons:
(1). The tight round and clamp it span too big
(2) in terms of packing belt width, tension is too big
(3). Tight round blocked by dirt or packaging tape residue
(4). Tight wheel teeth have been dulled.
The above problems, the solution is also has four kinds:
1. Increase the gaskets,
2. Use a small screwdriver, by regulating valve to adjust the packing belt tension
3. You blow dust gun or clean tight round brush teeth
4. Replace the tight round.
Fault 3:
separate pneumatic steel strap tensioning machine packaging, baling press forward, or can't clamp the end of the pack.In the cause of the failure is also there are three:
1. The clamp it is packaged with residual residual block
2. The teeth on the linking piece it has dulled
3. Packing strap tension is too big.
Solutions to corresponding to three kinds:
1. Clean the clamp it teeth, blow out the residue with blowing dust gun
2. Replace the clamp it
3. Use a small screwdriver, adjust the throttle valve.