Plastic strapping tool is a compressed air as the power source, the thermal bonding is the main bonding an alternative portable electric strapping tool that using a pneumatic device, the machine has the advantages of small volume, and easy to use, so favored by the customers. But plastic strapping machine is the use of compressed air as power, many users do not understand is how to achieve hot melt, the Ausense will introduce you the working principle of plastic strapping tool.
  The piston pneumatic strapping tool cylinder under the pressure of compressed air, the upper piston and the vibrator is and the positioning pin connected together, the vibrator on packing tape overlap. The vibrator has a central elliptical hole, the hole and the pneumatic motor eccentric shaft connection, pneumatic motor high speed (10000 RPM), which makes a rapid movement. Packaged with the lower triangle tooth die is fixed, the upper is driven by a triangular tooth vibrator, dramatic friction. In this way, packaged with the overlapping part overheating welding, when the timer reaches the set time, weld end. Packing the upper and lower belt in extrusion and bonded, standing for a few seconds, to ensure that the weld has been cooling.
   Plastic strapping tool pressure: the pressure range requirements for 72-100psi (5.0-7.0 bar). Source: filter Installation of pressure regulating valve - the lubricator component to be as close as possible to the pneumatic tools, air hose diameter minimum 6.0mm (1/4), gas supply pipe ends must be quick connector assembly. Water filter: shunt for gas path must be fitted with a drain valve at the bottom, water once a day. Lubrication: pneumatic motor must be properly lubricated, so it must be with good lubrication oiler.