Separate pneumatic steel strapping tool is one of the most good quality pneumatic equipment for steel strapping. this tool can divide into pneumatic seperation tensioner and pneumatic seperation sealer, this machine need two air supply, since this machine is light and convenient for separated use.
    
    But we will always face some trouble during strapping and how can we resolve it, now Qingdao Ausence give you some advice

1. The butter become freezing
     Put some HJ-10 machine oil to the air supply entrance, make it feed into the motor
     If the machine still can not start we need change the butter between Gear and planetary gear in the box.

2. The air supply not enough
     Except the air pressre of tensioner, we need also check the exhaust gas flow of the air pressure machine
     If the rubber tube inner diameter have decreaced by the oil corrosion, we need change a new tube.

3. Some dust come into the air motor
     If we sure that dust come into the air motor, please divide and clean it in tome
     We must check and clean the connection of tensioner and tube carfully to prevent the dust

4. The inner part been damage or worn-out
     When we finish the process above, but still can not start, we need immediately decomposition to check the internal parts to know whether it is damage or excessive wear loss, then replace the part in time.
    Air motor and gear gently rotating alone, so it is important to replace the part timely if there is a problem of any parts.
    
    Product recommend: Seperated pneumatic steel strapping tool