Today steel strapping machine was used widespread.But many people do not know steel strapping tool how to use.If you’re not sure steel strapping tool how to use , don't worry. These tools are easy to use and of the highest quality, so they do the job right the first time around. However, a little practice goes a long way, so be sure to brush up on these instructions prior to using the tools.Next i will tell yousteel strapping tool how to use.
  Insert the end of the band into the buckle and bend the band.
  Encircle the object, bringing the band through the buckle again.
  Insert the band into the nose of the tool and slide. Turn the tool handle to tighten.
  When the band stops moving through the buckle, the band has been successfully tightened.
  Reverse the handle with one turn, then roll the tool over the buckle.
  To cut the band, pull the handle. Remove the tool.
   Push the band stub between the buckle ears, then hammer this closed to complete the proper seal.

 Ratchet Tensioner Tools

  Slide the strap through the seal.
  Pull the strap through the seal, over the product, down the side and underneath.
  Thread the strap through the seal a second time.
  Bend back the under layer of the strapping so that there is a flap between the seal and the item.
  Pull the strap tightly around the item and through the seal.
  Hold the tensioner tool in your hand and line up the slots in the nose.
  Insert the strap through the nose.
  Hold the short handle in the right hand and push the long handle forward with the left hand. This will tighten the strap.
  Bring the long handle back to its original position, then take both handles and move them forward.
  Now push the small handle forward with your right hand to cut the strap.
  Hammer down the lugs to complete the seal.

 Tensioning Tools

  Place the strap around the item you’re looking to secure. The end of the strap should be underneath.
  Compress the handle to lift the support frame. In this position, move the tool and slide the strap into the tool.
  Hold the tool in your left hand and pump the handle until the strap is tightened.
  Press down the handle pawl so that the handle can be released. Place the seal open-side down over both straps in front of the tool.
  Open the sealer, put it on top of the seal and press the sealer handle together to crimp the seal. Remove the sealer. (Sealer not included)
  Press down on the handle to life the feedwheel. Slide the tool away from the strapping material. Cut excess strap with a steel strapping cutter.