Separate pneumaticsteel strapping tool is one of the most good quality pneumatic equipment for steel strapping tool. this tool can divide into pneumatic strapping tensioner and pneumatic sealer, this machine need two air supply, since this machine is light and convenient for separated use.But we will always face some trouble during strapping and how can we resolve it.But we will always face some trouble during strapping and how can we resolve it, now Qingdao Ausence give you some advice

  1. The butter become freezing Put some HJ-10 machine oil to the air supply entrance, make it feed into the motor If the machine still can not start we need change the butter between Gear and planetary gear in the box.

  2. The air supply not enough Except the air pressre of tensioner, we need also check the exhaust gas flow of the air pressure machine If the rubber tube inner diameter have decreaced by the oil corrosion, we need change a new tube.

  3. Some dust come into the air motor If we sure that dust come into the air motor, please divide and clean it in tome We must check and clean the connection of tensioner and tube carfully to prevent the dust

  4. The inner part been damage or worn-out. When we finish the process above, but still can not start, we need immediately decomposition to check the internal parts to know whether it is damage or excessive wear loss, then replace the part in time.Air motor and gear gently rotating alone, so it is important to replace the part timely if there is a problem of any parts.

  Product recommend: Seperated pneumatic steel strapping tool